Skip to main content

High water bill or low water pressure in a Miami-Dade home

How to check for leaks with your water meter, find toilet leaks, understand pressure regulators, and know when to call a licensed plumber in Miami-Dade.

By AV Construction Group Corp. Published 7 min read

Illustration for articles about plumbing

A sudden jump in your Miami-Dade water bill usually means water is going somewhere you cannot see, and the quickest check is the water meter. With every fixture off, a moving flow indicator or a changed meter reading two hours later points to a leak. Low pressure has a different set of causes, from a clogged fixture to a failing pressure regulator or a problem on the utility side. A licensed plumber can sort out whichever applies.

Start with the meter

Miami-Dade Water and Sewer (WASD) describes a simple test. The meter is typically in the front yard near the street or sidewalk, under a lid.

  1. Lift the meter-box lid and flip open the cap over the meter face. Clear away dirt.
  2. Write down the register numbers. The register works like a car odometer.
  3. Compare them to the current reading on your bill. The register should be equal to or higher than that number. If it is lower, the meter may have been misread, and WASD asks you to call Customer Relations at 305-665-7477 for a re-read.
  4. With all water off, look at the flow indicator. If it moves, water is flowing somewhere.
  5. If it is not moving, note the register, use no water for two hours, and read it again. A higher number suggests a leak.
  6. To tell inside from outside, close the house shutoff valve, usually on an outside wall where the line enters or near the water heater, and check again. If the meter keeps moving, the leak may be in the line between the meter and the house or in an outdoor water-using device. If it stops, the leak may be inside the home.

EPA's WaterSense program gives the same basic two-hour test.

Who is responsible for a leak

WASD says it maintains service up to and including the meter box. The account holder is responsible for all water used past the meter box, including concealed or underground leaks. The county does not repair leaks on private property and does not recommend plumbers.

Check the toilets next

Toilets are a common source of silent leaks. EPA suggests a dye test:

  1. Put a few drops of food coloring in the tank.
  2. Wait 10 minutes without flushing.
  3. If color appears in the bowl, the tank is leaking into it.
  4. Flush afterward so the dye does not stain.

EPA lists worn toilet flappers as a frequent culprit and suggests replacing them at least every five years. Other everyday sources are dripping faucets, leaking valves, showerheads with loose connections, hose connections, and irrigation systems. EPA gives examples of scale: a faucet dripping once per second can waste more than 3,000 gallons per year, and an irrigation leak only 1/32 of an inch wide can waste about 6,300 gallons per month. Its figures are national averages, not Miami-Dade measurements.

If the leak is not in a fixture

If the meter moves with the house valve closed, or the leak is inside walls or under the slab, you are into hidden-leak territory. A plumber can use specialized detection equipment. See slab leak signs, detection and repair and, for older systems with repeated leaks, aging pipes and repiping.

Will WASD adjust the bill?

WASD has a process for underground or concealed leaks. As the online request describes it:

  • The request must be submitted within 30 days of the department's notice about high water use, and repairs must be final.
  • Required items include a repair invoice from a licensed professional (or, for minor DIY repairs, a written statement and purchase receipt) and before-and-after photos.
  • WASD may inspect the repair before it is covered. If the meter still registers water at inspection, the repair is not considered final.
  • A $30 administrative fee applies, and processing can take up to 60 days.
  • For monthly-billed accounts, the form says adjustments are granted only to the sewer portion of the bill.
  • Prior balances must be paid, with a partial payment.
  • A one-time lifetime option exists for consumption above six times the account's average quarterly use.

An older version of the form lists visible fixtures, such as toilets and water heaters, as ineligible. Terms and credit percentages may have changed, so ask WASD which version applies to your account before assuming a credit. Keep invoices and photos either way, and do not cover an underground repair until you have asked whether an inspection is needed.

Low water pressure: where to look

Start by narrowing down the pattern. Is it one fixture, hot water only, or the whole house? Does it affect neighbors? The answers point to different causes.

  • One fixture. Often a clogged aerator or showerhead, or a partly closed supply valve at that fixture.
  • Hot water only. Points toward the water heater or its connections.
  • Whole house. Could be a partly closed main valve, a failing pressure regulator, a leak, or a utility-side issue. For neighborhood problems, contact WASD through its main number at 305-665-7477 or 311.

Whatever the symptom, the meter test is a useful first step, because a leak and a pressure complaint can show up together.

Pressure regulators in plain terms

A pressure-reducing valve (PRV), also called a regulator, lowers the pressure that comes in from the utility to a level the home's fixtures can handle. Utility and manufacturer guidance treat 80 psi as the line above which pressure is considered too high. A. O. Smith's expansion tank manual says a PRV is needed if incoming pressure exceeds 80 psi and recommends keeping pressure at 60 psi or below. A San Diego utility guide describes a healthy adjusted range of 45 to 75 psi and lists warning signs of a damaged PRV: banging or whistling pipes, high pressure at faucets, and frequent toilet and faucet leaks.

So a damaged regulator is more often linked to high pressure and leaky fixtures than to weak flow, but a plumber should confirm rather than guess. A plumber can measure static pressure with a gauge at a hose bib. If the home has a regulator and a backflow device, the plumber should also check whether thermal expansion is being managed, because pressure can spike when the water heater runs. Pressure checks and any regulator replacement are a licensed plumber's job; ask whether your city requires a permit.

When to call a licensed plumber

  • The meter keeps moving with the house valve closed.
  • You hear running water or see damp walls, ceilings, warm floor spots, or soggy ground with no visible source.
  • Pressure is high, banging, or inconsistent.
  • You need an invoice and documentation for a leak adjustment request.
  • The repair involves opening walls, a slab, or the service line.

Miami-Dade's permit brochure says new plumbing work, including interior plumbing changes, needs a permit, and that only licensed contractors or owner-builders may obtain one. Ask whether your repair needs one.

Questions people ask

How do I know the meter reading was not just misread?

Compare the register to the current reading on your bill. If the register is lower than the bill, WASD says to call for a re-read and corrected bill.

Can a leak be outside my house but still my responsibility?

According to WASD, yes. The account holder is responsible for water use past the meter box, including underground leaks.

Is high pressure good?

Not necessarily. Pressure above about 80 psi is generally treated as excessive and can strain fixtures and appliances.

Check before you decide

  • Do the two-hour meter test and the toilet dye test before calling anyone.
  • Take photos of the meter readings and any repair.
  • Ask the plumber to measure pressure and explain the result.
  • Get a written invoice with the license number and the repair location.
  • Ask WASD about credit rules before you cover an underground repair.

See plumbing services.

Sources

  1. Miami-Dade Water and Sewer: Leak Detection Using the Water Meter
  2. Miami-Dade Water and Sewer: Contact and Account Information
  3. Miami-Dade Water and Sewer: Underground/Concealed Leak Adjustment Request
  4. Miami-Dade Water and Sewer: Leak Credit Request Form (older version)
  5. US EPA WaterSense: Fix a Leak Week
  6. City of San Diego: Residential Pressure Reducing Valve Guidelines
  7. A. O. Smith: Thermal Expansion Tank Manual
  8. Miami-Dade County: Home Renovation Permit Brochure

Planning a project?

Tell AV Construction Group Corp. about your project and we will follow up.

Keep reading

More guides on the blog