Rooftop units (RTUs) are packaged air conditioners that sit on a roof curb and serve a floor or a whole building. DOE says they typically last 15 to 20 years, and they are often replaced only after they fail. In coastal South Florida, the practical keys are a written maintenance schedule built on the manufacturer's manual, regular coil cleaning to fight salt and dirt, and a replacement plan made before an emergency.
Why RTUs get neglected
DOE's rooftop unit campaign says RTUs are used in over 60 percent of U.S. commercial buildings. A 2014 white paper from the Professional Retail Store Maintenance Association (PRSM) says RTUs are often neglected because they are out of sight and "are replaced only after they fail."
A maintenance schedule built from reputable sources
There is no single schedule for every unit. Start with the manufacturer's installation, operation and maintenance manual for your model, and some warranties require following it (see the coil coating note below).
As one example, Carrier's service manual for its 3-to-5-ton WeatherMaster 48QE rooftop unit (date code 6-26) says to check items every month or two until a specific schedule is set for the installation. It recommends these checks:
| Interval | Tasks (Carrier 48QE example) |
|---|---|
| Quarterly (and 30 days after start-up) | Replace return-air filters, clean outdoor hood inlet filters, check condenser coil cleanliness, check the condensate drain |
| Start of each season, or more often | Check refrigerant charge, wiring and terminal tightness, fan and compressor mounting, indoor coil cleanliness, blower amperage, economizer dampers and filters |
| After evaporator coil cleaning | Flush the condensate pan |
Larger units have belts, different controls and more stages, so their schedules differ. Treat the table as an illustration of how a manufacturer structures it.
A second reference is ANSI/ASHRAE/ACCA Standard 180, which sets baseline inspection and maintenance requirements for HVAC systems in new and existing commercial buildings. DOE's Better Buildings site lists the 2022 edition. Ask a service contractor whether their program follows Standard 180, and obtain the standard for the exact task list.
An ASHRAE Journal article on rooftop air conditioners advises doing air-side maintenance and repairs, such as filters and coils, before the refrigeration system, because refrigerant charge measurements are unreliable if dirty filters restrict airflow.
What property managers can ask for
- A written preventive maintenance scope per unit, by interval.
- Service reports with the date, unit tag and findings.
- A running list of repairs by unit, which also helps with replacement planning.
- Proof of the technician's license and the work permitted when required. See AC permits and licensing in Miami-Dade.
Coastal corrosion and coil care
Salt air attacks coil fins and tubing, and dirt on a coil reduces performance. Carrier's manual recommends monthly cleaning of the outdoor condenser coil and says that at coastal or industrial sites a periodic low-velocity clean-water rinse is "very beneficial." It warns against high-pressure washers, garden-hose jets, compressed air and harsh or acidic cleaners, which can bend fins or accelerate corrosion, and says failing to clean coils can reduce durability in the environment. The manual gives no fixed interval for indoor coil cleaning beyond the seasonal checks.
Manufacturers also sell coil protection. AAON describes a factory-applied polymer e-coat for condenser and evaporator coils for coastal and similar settings, and says following its coil cleaning and record-keeping instructions is a condition of the coating warranty. Trane describes an electrocoated condenser coil option and compares it with phenolic and field-sprayed coatings. These are manufacturer claims in product literature, and options vary by brand and model. When pricing a new unit near the coast, ask which coil protection is available, whether it covers both coils and what maintenance the warranty requires.
The Carrier manual refers to "coastal or industrial" sites but does not define how close to the water that means. Ask the manufacturer how it classifies your property.
Signs a unit is nearing replacement
DOE's campaign page and the PRSM paper point to age as the starting point. PRSM treats units older than 10 years as candidates for high-efficiency replacement. Other things to track:
- Repeated repairs on the same unit or a rising service history.
- Corroded coils, cabinet or curb.
- Refrigerant leaks. Ask what refrigerant the unit uses; see R-410A to A2L refrigerant transition.
- Comfort complaints, short cycling or high energy use relative to similar units.
Planning a replacement before it fails
The PRSM white paper describes a planned program as an alternative to a "run to fail" approach that led to costly emergency replacements for one retailer. It suggests:
- Build an inventory with age, tonnage, location and repair history.
- Review the building load. Lighting upgrades, reduced infiltration and other changes may allow a smaller unit than the one being replaced.
- Compare efficiency using the ratings on each unit (EER and IEER in the paper) and the cost of the existing unit's degraded performance.
- Check controls. DOE says advanced controller retrofits can cut RTU energy use by up to 40 percent in its examples, and the paper discusses fan control and economizers. Results depend on the unit and use.
- Plan refrigerant recovery and disposal with proper documentation.
Equipment rules differ by size. AHRI notes that light commercial three-phase units under 65,000 Btu/h follow different requirements than residential equipment, with federal compliance required for units manufactured on or after January 1, 2025.
Permits and rooftop details
A replacement on a South Florida roof often involves more than the unit. The City of Hialeah's A/C replacement form, for example, asks for wind load calculations with anchoring details from the unit to the curb and the unit paneling, whether a new roof curb, adapter or stand is needed, and a copy of the unit's Notice of Acceptance or State Product Approval. Requirements vary by municipality, so confirm with the jurisdiction. Coordinate any curb or roof penetration work with your roofer. For related roof work, see roofing services.
Questions people ask
How often should rooftop units be serviced?
Follow the manufacturer's manual. Carrier's example calls for quarterly checks and seasonal checks, with more frequent coil cleaning in coastal areas.
How long do rooftop units last?
DOE and PRSM say 15 to 20 years is typical, though units can fail earlier or last longer.
Can I repair a corroded coil instead of replacing the unit?
It depends on the extent of damage and the unit's age. Ask for a written assessment that compares coil replacement with unit replacement.
Do I need a permit to replace an RTU?
Equipment replacement is generally handled through a mechanical permit, and Miami-Dade municipalities use their own forms, such as the Hialeah form above. Confirm with the building department before work starts.
Check before you decide
- Get the manufacturer's maintenance manual and put it in the contract scope.
- Ask for coil protection details and the cleaning method used.
- Request a unit inventory with ages and repair history.
- Ask whether the replacement needs a new curb, adapter and wind-load documents.
- Obtain at least two written proposals on the same scope.
For service planning, see HVAC services.
