A frozen evaporator coil means ice has formed on the indoor coil that cools your air. The usual causes are restricted airflow, such as a dirty filter, and low refrigerant from a leak. Turn the cooling off, replace a dirty filter, and call a licensed technician if ice returns. Do not chip or scrape the ice, because it can damage the coil and cause a refrigerant leak.
Why a coil freezes
The evaporator coil sits inside the air handler. Refrigerant inside it absorbs heat from the air blowing across it, and moisture from that air condenses on the cold surface and drains away. Ice forms when the coil surface drops below freezing and the water on it freezes instead of draining.
Restricted airflow
Trane calls this the most common cause. Less warm air crossing the coil means the coil gets too cold. Common reasons:
- A clogged or dirty filter.
- Blocked return vents or closed supply vents.
- A dirty evaporator coil, because dust insulates it.
- A weak or failing blower.
The U.S. Department of Energy notes that dirt on the evaporator coil reduces airflow and its ability to absorb heat, and that air bypassing a clogged filter can deposit dirt there. Carrier lists faulty fans and dirt buildup as mechanical causes.
Low refrigerant
Carrier explains that low refrigerant lowers pressure in the coil, making it cold enough to freeze moisture. Trane says low refrigerant usually points to a leak or an improper charge at installation. Carrier says a technician must find and repair a leak before recharging, so a low charge is a repair issue rather than routine upkeep. For background on refrigerants in newer equipment, see the R-410A to A2L refrigerant transition.
Thermostat and control problems
Trane lists a faulty thermostat as another cause. One of its articles points out that a coil which only freezes overnight may mean the thermostat is not shutting the system off properly. A technician can test controls.
Humidity and drainage
Florida's humid air carries a lot of moisture, so the coil has plenty of water to condense. That is normal. The trouble starts when airflow or refrigerant is off, because the coil then runs too cold. One contractor's guide also lists a blocked condensate drain or pan as a cause of freezing. Water that cannot drain stays on the coil. A drain float switch may shut the system off when water backs up. See clogged AC drain lines.
Manufacturer pages do not agree on how much humidity itself contributes, so treat it as a background factor rather than the root cause. If a system freezes repeatedly, a technician should measure airflow and refrigerant charge.
Signs of a frozen coil
- Visible ice on the indoor coil, its cabinet or the copper lines.
- Frozen refrigerant lines at the outdoor unit.
- Weak airflow from vents.
- A house that will not cool.
- Water around the indoor unit, especially when ice melts.
What to do first
- Set the thermostat to Off. Trane warns that running a system with a frozen coil can cause major damage. Carrier says it can strain the compressor.
- Check the air filter and replace it if it is dirty. Open any closed or blocked vents and returns.
- Look for water. As ice melts it can overflow the pan. Place towels, and if the drain looks overflowing, avoid running the system.
- Let the ice melt naturally. Carrier says this can take roughly 1 to 4 hours. Do not use heat guns, space heaters or hot water on the coil.
- Restart only when the coil is dry and airflow is strong. If ice comes back, leave it off and call.
Manufacturer advice differs on one detail. Some pages suggest running only the fan to speed thawing, while Trane's main troubleshooting page offers no thaw method and tells you to call the HVAC company. Trane's blog mentions a hair dryer on a low setting, but Carrier tells people not to use hair dryers. Because these sources conflict, the safest course is to let it thaw on its own and follow your technician's instructions.
Heat pump note
Trane's blog warns not to switch a heat pump into defrost mode when the indoor coil is frozen, because defrost mode only clears ice from the outdoor coil.
Why not chip or scrape the ice
Trane's blog uses block capitals to say not to chip the ice. Trane says chipping can damage the coil and cause a refrigerant leak, which makes the repair more expensive. Sharp tools and force are risky on a coil that already holds refrigerant under pressure. Carrier also says not to pour hot water on the coil or use heaters.
When to call a technician
- Ice returns after thawing and a clean filter.
- You suspect a leak, such as oily residue near the coil or hissing.
- The blower, thermostat or coil needs repair.
- The system has already run while frozen.
Technicians typically replace filters, clean a dirty coil, test refrigerant and check for leaks, then repair and recharge if needed, according to Trane. Ask for the findings, such as measured airflow and the source of any leak, and consider the system's age. See AC repair vs replacement in Miami if repairs recur.
Questions people ask
Will a frozen AC fix itself?
Carrier says no. The ice can melt, but the cause remains and it will freeze again. Fix the cause.
Can I just run the AC to melt it?
No. Running the compressor while the coil is iced can damage it, per Trane and Carrier.
How can I prevent it?
Replace filters regularly, keep vents open, keep landscaping at least 2 feet from the outdoor unit (Trane's guidance), and schedule yearly professional maintenance. See AC maintenance in humid, salty South Florida.
Check before you decide
- Is the filter clean and the right size?
- Are all vents and returns open?
- Is there water at the drain pan or a tripped float switch?
- Did ice return after thawing? If yes, call.
- Did a technician measure airflow and refrigerant charge, not just recharge?
